Bernoulli Box
{{Short description|Removable floppy disk storage system}}
{{More footnotes|date=September 2013}}
Image:20 MB Bernoulli disk cartridge.jpg
The Bernoulli Box (or simply Bernoulli, named after Bernoulli's principle) is a high-capacity (at the time of release) removable disk storage system that was Iomega's first widely known product. It was first released in 1982.
Overview
The original Bernoulli Box "Alpha-10" is a 10 MB removable disk drive that spins a disk made of PET film at about 1500 rpm,[http://www.bitsavers.org/pdf/iomega/00701300-000_IOMEGA_Alpha_10H_Technical_Description_Manual_Nov84.pdf IOMEGA Alpha 10H Technical Description Manual] 1 μm above a read-write head. Utilizing Bernoulli's principle, the rotation of the disk pulls the flexible disk media down towards the read/write head, and will continue to do so for as long as the disk is spinning. This was in an attempt to make the Bernoulli drive more reliable than a contemporaneous hard disk drive, since a head crash is made physically impossible: should the disk stop spinning for any reason, it immediately pulls away from the read/write head, preventing damage.
The Bernoulli Box was released in capacities of 10 and, later, 20 MB, and its cartridges measure 8.23 x 11.02 x 0.71 inches, about the size of a standard piece of letter paper (albeit thicker). Bernoulli Boxes could be configured at time of purchase for either one or two drives within a single enclosure. A drive subsystem can be connected to a host computer via a proprietary interface card that utilizes a 37-pin SCSI connector.
In 1985, a 5 MB, RS-422 serial version of the Bernoulli Box, specific to the original Macintosh and Macintosh 512K, was released. The cartridges for this Macintosh-only version have a smaller capacity of just 5 MB. However, they are also physically smaller than their predecessors, measuring just 5.5 x 7.4 x 0.53 inches. With the release of the Macintosh Plus in 1986 (and its on-board SCSI interface), the 5MB Bernoulli Box was quickly discontinued, and the 10 and 20 MB versions were adapted for the Macintosh Plus's 25-pin SCSI connector.
The most popular system was the Bernoulli Box II, whose cartridges are 13.6 cm wide, 14 cm long, and 0.9 cm thick, somewhat resembling a 5¼-inch standard floppy disk. The Bernoulli Box II was initially released with just a 20 MB capacity, but was quickly followed up by drives with capacities of 44 MB, then 90 MB (with varying levels of backwards compatibility). Eventually, a so-called "MultiDisk" drive was released which sported a maximum capacity of 150 MB, but which could also read and write without penalty to other "MultiDisk" cartridges, specifically: 35 MB, 65 MB, and 105 MB, in addition to 150 MB.
By 1993, a 230 MB Bernoulli Box was released which boosted the maximum possible capacity, and which was also backwards compatible with most previous capacities (albeit at a performance penalty).
Bernoulli Box II drives were sold as either internal units which fit into standard 5¼-inch drive bays, or as external units, with either one or two drives within a self-contained enclosure, similar to the original Bernoulli Box, and which connected to the host computer via the external SCSI connector.
All versions of the Bernoulli Box II use a SCSI interface, but external drives can also be converted for use with a Parallel port interface using a special adapter.
Cartridges for both the original Bernoulli Box, as well as the Bernoulli Box II, have a physical switch on them, analogous to that of a standard 3½-inch floppy disk, in order to enable and disable write protection.
Reception
PC Magazine in 1984 stated that the Bernoulli Box "... combines the advantages of [standard] floppy- and hard-disk systems without their drawbacks." It reported no software-compatibility problems and cited the box's durable design.{{r|pc19840918}} Bruce Webster of BYTE wrote favorably of the peripheral in February 1986, reporting that "I have not had a single glitch or lost file" in nine months of constant use.{{cite news | url=https://archive.org/stream/byte-magazine-1986-02/1986_02_BYTE_11-02_Text_Processing#page/n343/mode/2up | title=Programming Tool and the Atari ST | work=BYTE | date=February 1986 | accessdate=9 May 2015 | author=Webster, Bruce | pages=331}}
Successors
Iomega's later removable-storage products such as the Zip drive and Jaz and Rev removable hard disks did not use the Bernoulli technology.
References
External links
- {{cite web |url=http://www.brutman.com/Bernoulli_Box/Bernoulli_Box_A220H.html |title=The Bernoulli Box A220H
|last=Brutman |first=M |date=February 27, 2011 |access-date=April 29, 2019 }}
- {{cite web |url=http://www.fundinguniverse.com/company-histories/iomega-corporation-history/
|title=Iomega Corporation History |access-date=April 29, 2019}}
{{Iomega storage devices}}
Category:Iomega storage devices