IT8

The following is a list of the IT8 standards, according to the [http://www.npes.org/pdf/Bluebook.pdf NPES Standards Blue Book]:

This standard establishes a data exchange format to

enable transfer of numerical control information between diecutting systems and electronic prepress systems.

The information will typically consist of numerical control information used in the manufacture of dies. 37 pp.

This standard defines an input test target that will allow any

color input scanner to be calibrated with any film dye set used to create the target. It is intended to address the color transparency products that

are generally used for input to the preparatory process for printing and publishing. This standard defines the layout and colorimetric values of

a target that can be manufactured on any positive color transparency film and that is intended for use in the calibration of a photographic

film/scanner combination. 32 pp.

This standard defines an input test target that will allow any

color input scanner to be calibrated with any film dye set used to create the target. It is intended to address the color photographic paper

products that are generally used for input to the preparatory process for printing and publishing. It defines the layout and colorimetric values of

the target that can be manufactured on any color photographic paper and is intended for use in the calibration of a photographic paper/scanner

combination. 29 pp.

The purpose of this standard is to specify an input data

file, a measurement procedure and an output data format to characterize any four-color printing process. The output data (characterization) file

should be transferred with any four-color (cyan, magenta, yellow and black) halftone image files to enable a color transformation to be

undertaken when required. 29 pp.

File:IT8 color target by EGM Laboratories.jpg.]]

Calibrating all devices involved in the process chain (original, scanner/digital camera, monitor/printer) is required for an authentic color reproduction, because their actual color spaces differ device-specifically from the reference color spaces.

An IT8 calibration is done with what are called IT8 targets, which are defined by the IT8 standards.

;Example

Special targets, implementing the IT8.7/1 (transparent target) or IT8.7/2 (reflective target) standards, are needed for calibrating scanners. These targets consists of 24 grey fields and 264 color fields in 22 columns:

• Column 01 to 12: HCL color model, which differ in Hue, Chroma, and Lightness
• Column 13 to 16: CMYK-Colors Cyan, Magenta, Yellow, and Key (black) in different steps of brightness
• Column 17 to 19: RGB-Colors Red, Green, and Blue in different steps of brightness
• Column 20 to 22: undefined, producers' choice

After scanning such a target, an ICC profile gets calculated on the basis of reference values. This profile is used for all subsequent scans and assures color fidelity.

• List of colors
• Color chart
• Color calibration
• Color management
• Color mapping
• ICC profile

• Romano, Richard and Frank. (1998). The GATF encyclopedia of graphic communications. GATF Press.
• Digital Color Imaging Handbook; Gaurav Sharma; {{ISBN|978-0-8493-0900-7}}; 2002.

Category:Computer graphics

Category:American National Standards Institute standards

Category:Printing terminology

Category:Print production