Norfolk and Western M Class

By the mid-1900s, the Norfolk and Western Railway (N&W) primarily relied on 2-8-0 "Consolidation" type locomotives to pull the company's heavy freight trains.{{Harvp|Dressler|1995|p=40}} As freight traffic increased, the N&W decided to place orders for larger locomotives with longer boilers.{{Harvp|Dressler|1995|p=41}} While 2-8-2 "Mikado" locomotives were made available in the railroad industry by that time, the N&W opted to order locomotives with the 4-8-0 wheel arrangement over the 2-8-2, since they felt putting the weight of the firebox over the rear driving wheels, as opposed to the trailing wheels, would increase adhesion.

The 4-8-0 design the N&W created, classified as the M class, was destined to be an upgrade to the Railway's W2 class 2-8-0's. The pilot axle would carry the lightweight smokebox, and the rear driving wheels would carry the heavyweight {{convert|45|sqft|m2|0|adj=on}} firebox. The firebox would be extended to the back wall of the cab, leaving no room for decks to be installed—this design was similar to those on camelback locomotives, but the fireboxes on the M class were conventional, and the cabs were placed over them, as opposed to ahead of them, like on the camelbacks.{{Harvp|Dressler|1995|p=42}} The engineer and fireman would have to sit in separate sides adjacent to the firebox while operating an M class, and the fireman would often have to stand on the tender deck while shoveling coal.

The M class locomotives were also equipped with {{convert|56|in|mm|0|adj=on}} diameter driving wheels, {{convert|21x30|in|mm|0|abbr=out|adj=on}} cylinders, and a boiler pressure of {{convert|200|psi|kPa|0|adj=off}}, and the locomotives would be capable of producing {{convert|40,163|lbf|kN|0|adj=off}} of tractive effort. 75 of the first M class locomotives (Nos. 375-449) were delivered from the American Locomotive Company's (ALCO) Richmond, Virginia works from June 1906 to February 1907, and 50 (Nos. 450-499) were delivered from the Baldwin Locomotive Works of Philadelphia, Pennsylvania from April to August 1906.

The M class would prove to be a mainstay of N&W motive power, working in mainline, transfer, switching, and branch line service. Many members of the class would undergo modifications over the years, such as the addition of higher-capacity tenders, installation of power reverse gear, superheating, and the replacement of the original Stephenson valve gear with that of the Baker type. Popular in service, crews would come to affectionately nickname the locomotives “Mollies,” a moniker which stuck until their retirement in the late 1950s.

Following the initial success of the class Ms, the N&W would order more 4-8-0s of nearly identical design in the form of the M1s in 1907. These differed in their use of Walschaerts valve gear and piston valves in place of slide valves. This design change, however, severely affected the locomotives’ performance, largely due to a poorly-executed design. The valves’ centerlines, being offset from those of the pistons, resulted in excess running gear wear and improper valve timing. Unsurprisingly, as older motive power on the N&W would be phased out, the M1s were among the first to go.

Design shortcomings would plague the subsequent class of 4-8-0s, the M2s, as well. From their arrival in 1910, issues with poor riding qualities and steaming were apparent. Though utilizing a larger boiler than either the Ms or M1s, the M2s possessed a relatively small heating surface area in the firebox, resulting in considerable difficulty in maintaining steam. In spite of the issues (along with subsequent unsuccessful modifications), the M2s lasted in service for considerably longer than the M1s, being among the few larger examples of non-articulated freight power owned by the N&W. The last examples lasted in service until the late 1950s.

When larger locomotives arrived on the N&W, some of the M's were sent to work in switching and transfer service. After World War II, however, the N&W began exploring potential replacements, as many of the M’s had begun to show their age; the locomotives also failed to meet smoke abatement laws in many of the cities along the N&W network. In an experiment to address both issues, M2s Nos. 1100 and 1112 were extensively modified between 1947 and 1948, with No. 1100 being modified first. The boilers of both locomotives were rebuilt with shorter flues and combustion chambers. Induced draft fans, driven by steam turbines, were installed, along with mechanical stokers and water level controls; these were added so the locomotives could be left alone for long periods of time and gave rise to the nickname "Automatic Switcher”. Both locomotives were also fitted out with mechanical lubrication and modified tenders, providing an increase in water and coal capacity.

Though extensive, the experiment ultimately proved to be a short-lived failure. Several issues became apparent shortly after No. 1100 reentered service. The blades of the induced-draft fan were quickly eroded by cinders from the locomotive’s fire, and the relatively soft exhaust from the locomotive lead to smoke and ash becoming a frequent source of discomfort for crews. In spite of changes to the design with No. 1112, including increases in heating surface and boiler pressure, along with the installation of a cinder collector to return cinders to the firebox ahead of the induced-draft fan, both locomotives were retired in 1951. The issues encountered in the experiment and the advent of more modern motive power in the form of 0-8-0 switchers (both acquired secondhand from the Chesapeake and Ohio Railway and built in the N&W’s own Roanoke Shops) did little to prolong the service lives of the already subpar M2’s.

Two of the N&W's M Class locomotives have been preserved. One M Class, No. 433, is on static display, while the other M, No. 475, is operational and is used in tourist excursion service.

{{Main|Norfolk and Western 433}}

N&W 433 is currently on static display at the trail head of the Virginia Creeper Trail in Abingdon, Virginia.

{{Main|Norfolk and Western 475}}

N&W 475 was restored to operating condition by the Strasburg Rail Road (SRC) in Pennsylvania, and it is being used to pull excursion trains on SRC’s tourist line.

Three of the N&W's M2s have been preserved. Two of these, Both Nos. 1118 and 1151 have yet to be restored from scrapyard condition.

• No. 1134 has been cosmetically restored and is on display at the Railroad Museum of Virginia in Portsmouth, Virginia.
• No. 1118 is currently under the ownership of the National Railway Historical Society’s Roanoke Chapter.
• No. 1151 is part of the Virginia Museum of Transportation’s collection in Roanoke.

{{Commons category|Norfolk and Western Railway class M}}

• Norfolk and Western A class
• Norfolk and Western J Class (1879)
• Norfolk and Western J Class (1903)

• {{cite book

|last = Carling

|first = D. Rock

|title= 4-8-0 Tender Locomotives

|publisher = Drake Publishers Inc.

|year = 1972

|isbn = 087749-150-X

}}

• {{cite book |last1=Rosenberg |first1=Ron |last2=Archer | first2=Eric H. |year=1973 |title=Norfolk & Western Steam (The Last 25 Years) |location=New York, NY |publisher=Quadrant Press, Inc. |pages=11–16, 77–78 |isbn=0-915276-00-3 }}
• {{Cite magazine |last=Dressler |first=Thomas |date=August 1995 |title=Norfolk & Western's remarkable 4-8-0s |url=http://www.railfan.com/a081995.html |magazine=Railfan & Railroad |publisher=Carstens Publications |archive-url=https://web.archive.org/web/19980508103408/http://www.railfan.com/a081995.html |access-date=November 10, 2022|archive-date=1998-05-08 }}

M

Category:4-8-0 locomotives

Category:Baldwin locomotives

Category:ALCO locomotives

Category:Steam locomotives of the United States

Category:Railway locomotives introduced in 1906

Category:Freight locomotives

Category:Standard-gauge locomotives of the United States

Category:2′D steam locomotives