Thrust-specific fuel consumption

SFC is dependent on engine design, but differences in the SFC between different engines using the same underlying technology tend to be quite small. Increasing overall pressure ratio on jet engines tends to decrease SFC.

In practical applications, other factors are usually highly significant in determining the fuel efficiency of a particular engine design in that particular application. For instance, in aircraft, turbine (jet and turboprop) engines are typically much smaller and lighter than equivalently powerful piston engine designs, both properties reducing the levels of drag on the plane and reducing the amount of power needed to move the aircraft. Therefore, turbines are more efficient for aircraft propulsion than might be indicated by a simplistic look at the table below.

SFC varies with throttle setting, altitude, climate. For jet engines, air flight speed is an important factor too.

Air flight speed counteracts the jet's exhaust speed. (In an artificial and extreme case with the aircraft flying exactly at the exhaust speed, one can easily imagine why the jet's net thrust should be near zero.) Moreover, since work is force (i.e., thrust) times distance, mechanical power is force times speed. Thus, although the nominal SFC is a useful measure of fuel efficiency, it should be divided by speed when comparing engines at different speeds.

For example, Concorde cruised at 1354 mph, or 7.15 million feet per hour, with its engines giving an SFC of 1.195 lb/(lbf·h) (see below); this means the engines transferred 5.98 million foot pounds per pound of fuel (17.9 MJ/kg), equivalent to an SFC of 0.50 lb/(lbf·h) for a subsonic aircraft flying at 570 mph, which would be better than even modern engines; the Olympus 593 used in the Concorde was the world's most efficient jet engine.[https://www.pbs.org/wgbh/nova/transcripts/3203_concorde.html Supersonic Dream]"[http://www.srmuniv.ac.in/downloads/turbofan-2012.pdf The turbofan engine] {{Webarchive|url=https://web.archive.org/web/20150418181832/http://www.srmuniv.ac.in/downloads/turbofan-2012.pdf |date=2015-04-18 }}", page 5. SRM Institute of Science and Technology, Department of aerospace engineering However, Concorde ultimately has a heavier airframe and, due to being supersonic, is less aerodynamically efficient, i.e., the lift to drag ratio is far lower. In general, the total fuel burn of a complete aircraft is of far more importance to the customer.

{{Confusing section|reason=Unclear what the table is all about. How should it be used? For what should it be used? If it is supposed to state the units for different quantities, then established definitions for unit name, unit symbol, quantity name and so on should be used. See examples in the International System of units article: https://en.wikipedia.org/wiki/International_System_of_Units#Derived_units|date=February 2020}}

{{Thrust engine efficiency}}

The following table gives the efficiency for several engines when running at 80% throttle, which is approximately what is used in cruising, giving a minimum SFC. The efficiency is the amount of power propelling the plane divided by the rate of energy consumption. Since the power equals thrust times speed, the efficiency is given by

:$\backslash eta=V/(SFC\backslash times\; h)$

where V is speed and h is the energy content per unit mass of fuel (the higher heating value is used here, and at higher speeds the kinetic energy of the fuel or propellant becomes substantial and must be included).

• {{annotated link|Brake specific fuel consumption}}
• {{annotated link|Energies per unit mass}}
• {{annotated link|Specific impulse}}
• {{annotated link|Vehicle metrics}}

{{notelist}}

{{reflist}}

• [http://www.geae.com/engines/commercial/cf6/index.html GE CF6 website] {{Webarchive|url=https://web.archive.org/web/20110904041357/http://www.geae.com/engines/commercial/cf6/index.html |date=2011-09-04 }}
• [http://www.hq.nasa.gov/office/aero/events/encompat/soaeng.pdf NASA Cruise SFC vs. Year]
• [http://www.jet-engine.net/civtfspec.html SFC by Engine/Mfg] {{Webarchive|url=https://web.archive.org/web/20190627155423/http://www.jet-engine.net/civtfspec.html |date=2019-06-27 }}

{{DEFAULTSORT:Thrust Specific Fuel Consumption}}

Category:Engine technology

Category:Power (physics)